LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1455 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Throttle Position (TP) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Disconnect the throttle position (TP) sensor electrical connector.
  3. Remove the 2 screws and the TP sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals