LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1455 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Cylinder Head Temperature (CHT) Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  2. Detach the cylinder head temperature (CHT) sensor cover and position aside.
  3. Disconnect the CHT electrical connector.
  4. Remove and discard the CHT.
    • To install, tighten to 12 Nm (9 lb-ft).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals