LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1455 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Crankshaft Position (CKP) Sensor >> Removal

Crankshaft Position (CKP) Sensor: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Disconnect the battery ground cable. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Remove the 5 bolts and the RH splash shield.
  4. Remove the engine plug bolt.
    Fig 1: Locating Engine Plug
    G04619699Courtesy of FORD MOTOR CO.
  5. Turn the crankshaft pulley bolt to position the number one cylinder at top dead center and install the special tool.
    Fig 2: Identifying Special Tool
    G03897707Courtesy of FORD MOTOR CO.
  6. Disconnect the crankshaft position (CKP) sensor electrical connector.
  7. Remove the bolts and the CKP sensor.
scientia non olet · About LEMON Manuals