Speed Control Servo/Actuator: Removal
WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Push in locking arm on speed control actuator cable cap. Rotate speed control actuator cable cap counterclockwise and separate from speed control servo/actuator. See Figure. Depress spring retainer and slide cable end rearward out of speed control servo/actuator pulley. Disconnect electrical harness connector. Remove mounting bolts and remove speed control servo/actuator assembly from vehicle. Remove bracket screws and remove bracket from speed control servo/actuator.