Tire Pressure Monitoring System (TPMS) Sensor: Disassembly

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Tire pressure sensors are manufactured in multiple colors based on their application. When installing a new sensor, make sure the color of the sensor being installed matches the color of the sensor that was removed. The different colored sensors are not interchangeable.

NOTE: The sensor can be removed and installed without removing the strap or the cradle.

NOTE: Tire pressure sensors are equipped with Lithium-ion batteries and must be disposed of accordingly.

CAUTION: The sensor, cradle and strap may be damaged by incorrect tire mounting or dismounting. Dismount the tire only as instructed.

Remove the tire from the wheel. For additional information, refer to WHEEL AND TIRE in this article.

CAUTION: Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor locking clip may occur.

Fig 1: Locating Sensor Locking Clip

Courtesy of FORD MOTOR CO.

Using a pocket screwdriver or similar tool, remove the sensor locking clip.

CAUTION: Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor may occur.

Fig 2: Detaching Sensor From Cradle

Courtesy of FORD MOTOR CO.

Using a pocket screwdriver or similar tool, detach the sensor from the cradle.
Remove the sensor.