LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1442 (Transfer Case - Four-Wheel Drive Systems) >> Removal And Installation >> Four Wheel Drive (4WD) Control Module >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Four Wheel Drive (4WD) Control Module Components
G04621128Courtesy of FORD MOTOR CO.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Disconnect the electrical connector.
  3. Lift upward on the module to release the fasteners from the shifter base. Remove the four wheel drive (4WD) control module.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals