Valve Spring, Retainer, and Seal: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Lubricate the valve guide with clean engine oil.

1.
Using the Valve Stem Oil Seal Installer, install the valve seal.

Courtesy of FORD MOTOR COMPANY

2.

Using the Valve Spring Compressor, install the valve spring, retainer and key.

Courtesy of FORD MOTOR COMPANY

3.

Install the camshaft roller followers. For additional information, refer to Camshaft Roller Follower .