Crankshaft Pulley: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

1.

Lubricate the front cover and the crankshaft front seal inner lip with clean engine oil.

NOTE: The crankshaft pulley must be installed and the bolt tightened within 4 minutes of applying the silicone gasket and sealer.

NOTE: Clean the keyway and slot using metal surface prep before applying silicone gasket and sealer.

2.
Apply silicone gasket and sealant to the end of the keyway slot.

Courtesy of FORD MOTOR COMPANY

NOTE: Lubricate the outside diameter sealing surface with clean engine oil.

3.
Using the special tool, install the crankshaft pulley.

Courtesy of FORD MOTOR COMPANY

4.

Install the bolt and washer. Using the special tool to hold the crankshaft pulley, tighten the bolt in 4 stages:
- Stage 1: Tighten to 120 Nm (89 lb-ft).
- Stage 2: Loosen one full turn.
- Stage 3: Tighten to 50 Nm (37 lb-ft).
- Stage 4: Tighten an additional 90 degrees.

Courtesy of FORD MOTOR COMPANY