LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 144 (Power Windows - BLACKWOOD) >> Component Tests >> Accessory Delay & One-Touch Down Relays

Accessory Delay & One-Touch Down Relays

WARNING: This page is about a different car, the 2002 Lincoln Blackwood. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove relay. Measure resistance between relay terminal No. 85 and all other terminals. See Figure. If all resistances are more than 5 ohms, go to next step. If any resistance is 5 ohms or less, replace relay.
  2. Connect one jumper wire between relay terminal No. 30 and positive battery terminal. Measure voltage between ground and relay terminal No. 87A. See Figure. If battery voltage exists, go to next step. If battery voltage does not exist, replace relay.
  3. Connect second jumper wire between relay terminal No. 86 and positive battery terminal. Connect third jumper wire between terminal No. 85 and ground. Check for voltage at terminal No. 87. If battery voltage does not exist, replace relay. If battery voltage exists, relay is okay.
scientia non olet · About LEMON Manuals