Oil Pan: Removal
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the air cleaner outlet pipe. For additional information, refer to REMOVAL AND INSTALLATION .
- Loosen the 2 top bellhousing-to-engine bolts 5 mm (0.19 in).
- Working from the top of the vehicle, loosen the 2 rear lower engine-to-bellhousing bolts 5 mm (0.19 in).
- Working from under the vehicle, loosen the 2 upper engine bracket-to-power transfer unit (PTU) bolts 5 mm (0.19 in).
- Remove the 7 retainers and the LH splash shield.
- Remove the oil level indicator and tube. For additional information, refer to OIL LEVEL INDICATOR AND TUBE .
- Loosen the 2 front lower bellhousing-to-engine bolts 5 mm (0.19 in).
- Loosen the 1 (manual transmission) and 2 (automatic transmission) rear lower engine-to-bellhousing bolt 5 mm (0.19 in).
- Remove the 2 oil pan-to-bellhousing bolts.
- Remove the 2 bellhousing-to-oil pan bolt.
- Slide the transmission rearward 5 mm (0.19 in).
- Drain the engine oil.
- Install the drain plug.
- To install, tighten to 28 N.m (21 lb-ft).
- Remove the 4 engine front cover-to-oil pan bolts.
- Remove the 13 bolts and the oil pan.
All vehicles
CAUTION:
To prevent damage to the transmission, do not loosen the transmission-to-engine bolts more than 5 mm (0.19 in).
All wheel drive (AWD) vehicles
All vehicles
Front wheel drive (FWD) vehicles
All vehicles