LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Front Suspension System) >> Removal And Installation >> Stabilizer Bar Link >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS & TIRES .
    2. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer bar link nut.
  2. Remove the upper stabilizer bar link nut.
    • To install, tighten to 63 Nm (46 lb-ft).
    3. NOTE: Use the hex holding feature to prevent the ball stud from turning while removing or installing the stabilizer link nut.
  3. Remove the lower stabilizer bar link nut.
    • To install, tighten to 55 Nm (41 lb-ft).
    4. NOTE: Inspect the stabilizer bar link ball joints and boots for wear. If necessary, install new parts.
  4. Remove the stabilizer bar link.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals