LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1437 (Front Suspension System) >> Removal And Installation >> Lower Arm >> Removal

Lower Arm: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The ride height is measured from the center of the halfshaft spindle to the edge of the fender.
  1. For reference during the installation of the lower arm, measure the distance between the center of the wheel hub and the lip of the fender with the weight of the vehicle resting on the wheel and tire assemblies.
  2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  3. Remove the lower ball joint pinch bolt nut and the pinch bolt.
  4. Separate the lower ball joint from the wheel knuckle.
  5. Remove the front lower arm bolt.
  6. Support the subframe.
  7. Remove the rear lower arm bolt and the lower arm.
scientia non olet · About LEMON Manuals