LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1435 (Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Output Shaft Seal >> Removal

Output Shaft Seal: Removal

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This procedure applies to vehicles equipped with automatic transaxles.
  1. Remove the power transfer unit (PTU) rear output shaft flange. For additional information, refer to OUTPUT FLANGE .
  2. Remove the deflector.
  3. Remove the PTU rear output shaft oil (pinion) seal.
    Fig 1: Locating PTU Rear Output Shaft Oil
    G04621133Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals