Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Make sure that the mating surface is clean before installing the new seal.

Fig 1: Identifying Special Tool (205-133)

Courtesy of FORD MOTOR CO.

Using the special tool, install the seal.

NOTE: Lubricate the pinion flange with premium long-life grease.

Fig 2: Locating Index Marks And Positioning Pinion Flange

Courtesy of FORD MOTOR CO.

Line up the index marks and position the pinion flange.
Using the special tool, install the pinion nut.
- Tighten to 244 nm (180 lb-ft).
  
  Fig 3: Identifying Special Tool (205-126)
  Courtesy of FORD MOTOR CO.
Line up the index marks and install the rear driveshaft universal joint.
- Install the 2 cap straps and the 4 bolts.
- Tighten to 23 nm (17 lb-ft).
  
  Fig 4: Locating Cap Straps And Bolts
  Courtesy of FORD MOTOR CO.