Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Open the liftgate window glass.
- Remove the 2 liftgate window glass nut access covers.
- Through the RH access, disconnect the liftgate window glass electrical harness connector.
- Disconnect the LH heated window grid wire electrical connector.
- Disconnect the 2 liftgate window glass cylinders.
- Slide the spring retainer to the end of the socket.
- Disconnect the socket from the ball stud.
- Remove the 2 liftgate window glass hinge nuts and the liftgate window glass.
- To install, tighten to 7 Nm (62 lb-in).
- To install, reverse the removal procedure.
- Transfer components as necessary.
NOTE:
An assistant may be needed to carry out this step.
NOTE:
An assistant may be needed to carry out this step.