LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1431 (Windows And Glass) >> Removal And Installation >> Door Glass Top Run - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door window regulator. For additional information, refer to WINDOW REGULATOR - REAR DOOR  in this article.
  2. Position the rear door window glass to the full down position.
  3. Remove the 2 screws and the rear door exterior sail panel.
  4. Remove the interior door glass weatherstrip.
  5. Remove the exterior door glass weatherstrip.
  6. Remove the 2 rear door glass top run bolts.
    • To install, tighten to 6 Nm (53 lb-in).
  7. Position the rear door window glass down and forward.
  8. Remove the rear door glass top run.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals