Brake Fluid Replacement
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Use of any other than the approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes inoperative. Failure to follow these instructions may result in personal injury.
WARNING:
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in personal injury.
CAUTION:
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash the surface with water.
CAUTION:
Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the master cylinder reservoir filled with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION:
Do not allow the master cylinder brake fluid to overflow from the reservoir. Brake fluid may damage the high-voltage components.
NOTE:
Bleeding the HCU is required only when removing or installing the HCU, master cylinder, or opening the lines to the HCU.
NOTE:
Make sure that the brake fluid level is above the MIN mark.
- Connect the diagnostic tool.
- Access the service bleed function. Access the service bleed function on the diagnostic tool and follow the directions.
NOTE:
Adequate voltage to the HCU module is required during the system bleed.