Engine Accessory Test
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
To carry out this test, proceed as follows:
- Remove the accessory drive belts.
- Increase the engine rpm to where the concern occurs.
- If the vibration/noise is duplicated when carrying out this test, the belts and accessories are not sources.
- If the vibration/noise was not duplicated when carrying out this test, install each accessory belt, one at a time, to locate the source.
WARNING:
Block the front and rear wheels, and apply the parking brake and the service brake, or injury to personnel can result.
CAUTION:
Limit engine running time to one minute or less with the belts removed or serious engine damage will result.
NOTE:
A serpentine drive belt decreases the usefulness of this test. In these cases, use a vibration analyzer, such as the EVA, to pinpoint accessory vibrations. An electronic listening device, such as an EngineEAR, will also help to identify noises from specific accessories.