Rear Sliding Window Motor

WARNING: This page is about a different car, the 2002 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

Remove bolts from rear seat and remove rear seat. Remove safety belt guide bolt and position safety belt guide out of the way. Remove push pin-type retainer from upper trim panel on passenger's rear "B"pillar and remove trim panel. Remove rear scuff plate on passenger's side of vehicle. Remove lower trim panel from passenger's rear "B"pillar by removing the push pin-type retainers. Detach rear sliding window cable from retainer. Disconnect electrical connector from rear sliding window motor. Remove bolts from rear sliding window motor bracket. Remove 4 screws from power sliding window cable. Remove rear sliding window motor assembly. To install, reverse removal procedure. During installation, ensure that the slot in sliding rear window cable is lined up with the tap on the sliding rear window glass.