LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Bumper System) >> Removal And Installation >> Bumper Bracket - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper. For additional information, refer to BUMPER ISOLATOR - FRONT .
  2. Remove the 8 front bumper bracket nuts (4 each side), front bumper brackets, and the front bumper bracket plates.
    • To install, tighten to 30 Nm (22 lb-ft).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals