LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1414 (Wiper System & Washer System) >> Removal And Installation >> Wiper Mounting Arm and Pivot Shaft >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the cowl grille. For additional information, refer to FRONT END BODY PANELS .
  2. Remove the 2 nuts and position the evaporative emission canister purge valve aside.
    • To install, tighten to 6 Nm (53 lb-in).
  3. Remove the 6 bolts and position the wiper mounting arm and pivot shaft aside.
    • To install, tighten to 12 Nm (9 lb-ft).
  4. Disconnect the windshield wiper motor electrical connector.
  5. Disconnect the windshield washer hose and remove the wiper mounting arm and pivot shaft.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals