LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1412 (Instrument Panel And Console) >> Removal And Installation >> Instrument Cluster Finish Panel >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. If equipped with steering column shift, place the transmission range selector lever in the 1 position.
    2. NOTE: Ignition switch must be in OFF position if disconnecting the passenger airbag deactivation (PAD) indicator electrical connector. Otherwise, a diagnostic trouble code (DTC) will be set in the restraints control module (RCM) memory and must be erased before releasing the vehicle.
  2. Position the ignition switch in the OFF position.
  3. Remove the audio unit. For additional information, refer to INFORMATION AND ENTERTAINMENT SYSTEMS .
  4. Remove the RH instrument panel finish panel and disconnect the 3 electrical connectors.
  5. Remove the LH instrument panel finish panel and disconnect the electrical connector.
  6. Tilt the steering column in the full down position.
  7. Remove the 8 screws and the instrument cluster finish panel.
    • Disconnect the electrical connectors.
    • To install, tighten to 3 Nm (27 lb-in)
  8. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals