LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Seat System) >> Disassembly And Assembly >> Seat Armrest - Rear >> Disassembly and Assembly

Disassembly and Assembly

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  1. For police vehicles equipped with a fire suppression system, depower the system.
  2. Remove the armrest. For additional information, refer to SEAT ARMREST - REAR .
  3. Remove the rubber inserts from the armrest cup holder.
  4. Remove the 2 screws from the armrest cup holder.
  5. Remove the 2 pivot screws from the armrest.
  6. Remove the hog rings.
    Fig 1: Removing Hog Rings
    G04586016Courtesy of FORD MOTOR CO.
  7. Remove the armrest trim cover.
  8. To assemble, reverse the disassembly procedure.
  9. Install the armrest. For additional information, refer to SEAT ARMREST - REAR .
    10. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  10. For police vehicles equipped with a fire suppression system, repower the system.
scientia non olet · About LEMON Manuals