Heated Seat
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
If a passenger seat cushion heater mat is faulty, a new OCS service kit must be installed and a new cushion heater mat must be installed to the OCS service kit foam pad.
NOTE:
When installing an OCS service kit equipped with heated seats, a new seat cushion heater mat must be installed. Do not re-use the original equipment manufacture (OEM) OCS cushion heater mat. The OCS service kit does not come with a cushion heater mat.
NOTE:
When installing a new driver seat heater mat (cushion or backrest) or passenger seat backrest heater mat, a new foam pad with the heater mat already attached is required. A new heater mat by itself is not available for service for the driver seat.
Each heated seat is controlled by a switch on the door trim panel.
The heated seat system:
- will only operate with the ignition switch in RUN.
- will operate with battery voltage as low as 9 volts.
- will maintain a temperature automatically once it is selected.
- will heat to the selected temperature each time the ignition switch is turned to RUN if the heated seat is not switched OFF.