Exhaust System Backpressure
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2003 Mercury Mountaineer, 2003 Lincoln Navigator, 2003 Lincoln Blackwood, 2003 Lincoln Aviator, and 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
Using a vacuum or pressure gauge, check exhaust system. Remove Heated Oxygen Sensor (HO2S) or air injection check valve (if equipped). Connect a 0-5 psi pressure gauge. Backpressure should be less than 3 psi at idle and less than 8 psi at wide open throttle. If exhaust system backpressure is greater than specified, exhaust system or catalytic converter is plugged.
If using a vacuum gauge, connect vacuum gauge hose to intake manifold vacuum port, and start engine. Observe vacuum gauge. Open throttle part way and hold steady. If vacuum gauge reading slowly drops after stabilizing, check exhaust system for restrictions.