LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1402 (Fire Suppression System) >> Removal And Installation >> Fire Suppression Manifold >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fire suppressor. For additional information, refer to FIRE SUPPRESSOR .
  2. Remove and discard the 5 fire suppression manifold bolts.
      NOTE: Apply the threadlock material provided in the new manifold kit when installing the new bolts.
    • To install, tighten to 3 Nm (27 lb-in).
    3. NOTE: In the event of a fire suppression system deployment, new fire suppression manifolds must be installed.
  3. Remove the fire suppression manifold.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals