LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1400 (Anti-Theft System - Perimeter) >> Removal And Installation >> Door Disarm Switch >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the LH front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Disconnect the door lock cylinder actuating rod from the door lock cylinder actuating pawl.
  4. Remove the E-clip.
  5. Remove the door lock cylinder actuating pawl.
  6. Disconnect the electrical connector and remove the door disarm switch.
  7. To install, reverse the removal procedure.
    • The door disarm switch mark must be positioned towards the harness side of the switch prior to installation
      Fig 1: Identifying Anti-Theft Inhibit Switch Mark
      G04585676Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals