Removal & Installation: Q45: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2000 Infiniti QX4, 2000 Infiniti Q45, 2000 Infiniti I30, 2000 Infiniti G20, and 1999 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.

To install, reverse removal procedure. Tighten bolts to specification. See Figure . Ensure bolts are installed in proper location according to length. See BOLT LOCATION & LENGTH (Q45) table. After torque converter is installed to drive plate, rotate crankshaft several turns to ensure transmission rotates freely. Check transmission fluid. Move selector through all positions to ensure transmission operates correctly. Perform road test.

BOLT LOCATION & LENGTH (Q45)

Bolt Number ⁽¹⁾

Length - In. (mm)

2.76 (70)

3.54 (90)

⁽¹⁾	Use illustration for bolt location. See Fig 1 .

Fig 1: Locating Transaxle Bolts (Q45)

Courtesy of NISSAN MOTOR CO., U.S.A.