Removal & Installation: G20: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2000 Infiniti QX4, 2000 Infiniti Q45, 2000 Infiniti I30, 2000 Infiniti G20, and 1999 Infiniti QX4. However, it is still accessible from the selected car via links, so may be relevant.
To install, reverse removal procedure. After connecting torque converter to drive plate, rotate crankshaft several turns to ensure transaxle rotates freely. Tighten bolts to specifications. See TORQUE SPECIFICATIONS . Install bolts in proper location according to length. See BOLT LOCATION & LENGTH (G20) table. Check transaxle fluid. Move selector through all positions to ensure transaxle operates correctly. Perform road test.
BOLT LOCATION & LENGTH (G20)
| Bolt Number (1) | Length - In. (mm) | ||
|---|---|---|---|
| 1 | 2.17 (55) | ||
| 2 | 1.97 (50) | ||
| 3 | 2.56 (65) | ||
| 4 | 1.38 (35) | ||
| 5 | 1.85 (47) | ||
|
|||