Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

Remove the pin-type retainer and position the luggage compartment trim aside.

Fig 1: Removing Pin-Type Retainer
Courtesy of FORD MOTOR CO.
Remove the 3 nuts and the rear lamp assembly.
- Disconnect the electrical connectors.
- To install, tighten to 5 Nm (44 lb-in).
  
  Fig 2: Nuts And Torque Specification (Rear Lamp Assembly)
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.