Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Make sure the ignition switch and the headlamp switch are in the OFF position.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 4 screws and the lower radiator air deflector.
- Detach the electrical connector locator pin.
- Remove the 2 bolts and the fog lamp.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.