Autolamps Time Delay Adjustment

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

To program the time lapse, carry out the following sequence:

NOTE: Steps 2 through 5 must be carried out within a 10-second period.

Start with the ignition switch in the OFF position and the headlamp switch in the AUTOLAMPS position.
Place the headlamp switch in the OFF position.
Place the ignition switch in the RUN position.
Place the ignition switch in the OFF position.
Place the headlamp switch in the AUTOLAMPS position.
- At this point, the exterior lamps turn on.
At the desired autolamp time delay, place the headlamp switch in the OFF position.
- At this point, the exterior lamps turn off and the time delay is set.