LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1394 (Information Center And Entertainment System) >> Removal And Installation >> Antenna Lead-in Cable >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the audio unit. For additional information, refer to AUDIO UNIT .
  2. Remove the RH lower instrument panel insulator.
    1. Remove the pin-type retainers.
    2. Release the locking tab.
    3. Remove the insulator.
    • Disconnect the courtesy lamp.
      Fig 1: Positioning RH Lower Instrument Panel Insulator Aside
      G04585427Courtesy of FORD MOTOR CO.
  3. Disconnect the antenna lead-in cable.
  4. Disengage the antenna lead-in cable pin-type locator retainer.
    Fig 2: Locating Antenna Lead-In Cable Pin-Type Locator Retainer
    G04585428Courtesy of FORD MOTOR CO.
  5. Remove the 3 retainers and the antenna lead-in cable.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals