LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1379 (Exhaust System) >> Diagnosis And Testing >> Exhaust System >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: If equipped with fire suppression system, refer to FIRE SUPPRESSION SYSTEM for important safety warnings.
  1. Verify the concern by running the engine (with the vehicle on the ground) or road testing the vehicle to duplicate the condition.
  2. Visually inspect the components of the exhaust system and related controls that may affect exhaust gas quality or loss of power.
  3. Visually inspect for obvious signs of mechanical damage. Refer to VISUAL INSPECTION CHART .
    VISUAL INSPECTION CHART

    Mechanical
    • Exhaust pipe pinched or crushed
    • Damaged muffler
    • Broken or damaged exhaust hanger brackets
    • Damaged catalytic converter
    • Cracked exhaust manifold
    • Dirty engine air cleaner
    • Loose or damaged heat shields
  4. Verify that the exhaust system is installed correctly, with clamps correctly located and tightened to specification.
  5. If the fault is not visually evident, determine the symptom. GO to SYMPTOM CHART .