LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1378 (Automatic Transmission External Controls) >> Diagnosis And Testing >> External Controls >> Pinpoint Tests >> Pinpoint Test G: The Control Linkage Is Binding - Floor Shift

Pinpoint Test G: The Control Linkage Is Binding - Floor Shift

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. G1 CHECK THE SHIFT CONTROL COMPONENTS FOR DAMAGE 
      WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
    • With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
    • Gain access to the shift control components.
    • Key in ACCESSORY position.
    • Apply the brake pedal.
    • Observe all shift control components while attempting to shift the selector lever through all ranges.
    • Are any of the components damaged? 

    Yes  : REPAIR as necessary. REINSTALL all components. TEST the system for normal operation. If equipped with fire suppression system, GO to  G4.

    No  : GO to G2.

  2. G2 CHECK THE SHIFT CONTROL COMPONENT OPERATION WITH THE SELECTOR LEVER CABLE DISCONNECTED FROM THE TRANSMISSION 
    • Key in OFF position.
    • With the vehicle in NEUTRAL, position it on a hoist. Refer to JACKING & LIFTING .
    • Disconnect the selector lever cable from the manual control lever.
    • Lower the vehicle.
    • Key in ACCESSORY position.
    • Apply the brake pedal.
    • Observe the shift control components while attempting to shift the selector lever through all ranges.
    • Do the components move fluidly through all ranges? 

    Yes  : REFER to AUTOMATIC TRANSAXLE/TRANSMISSION for internal transmission repair. If equipped with fire suppression system, GO to  G4.

    No  : GO to G3.

  3. G3 CHECK THE SHIFT CONTROL COMPONENT OPERATION WITH THE SELECTOR LEVER CABLE DISCONNECTED FROM THE FLOOR SHIFT MECHANISM 
    • Key in OFF position.
    • Disconnect the selector lever cable from the floor shift mechanism.
    • Key in ACCESSORY position.
    • Apply the brake pedal.
    • Observe the shift control components while attempting to shift the selector lever through all ranges.
    • Do the components move fluidly through all ranges? 

    Yes  : INSTALL a new selector lever cable and bracket. REFER to SELECTOR LEVER CABLE AND BRACKET - FLOOR SHIFT . TEST the system for normal operation. If equipped with fire suppression system, GO to G4.

    No  : INSTALL a new floor shift mechanism. REFER to SELECTOR LEVER - FLOOR SHIFT . If equipped with fire suppression system, GO to G4.

  4. G4 REPOWER THE FIRE SUPPRESSION SYSTEM 
      WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
    • Verify that the fire suppression system is repowered. Refer to FIRE SUPPRESSION SYSTEM .
    • Is the fire suppression system repowered? 

    Yes  : Fire suppression system repowering is complete.

    No  : REFER to FIRE SUPPRESSION SYSTEM for fire suppression system depowering and repowering procedure.

scientia non olet · About LEMON Manuals