Other Concerns: No Engine Braking In Manual 2nd Or Manual 1st Position

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.

OTHER CONCERNS - NO ENGINE BRAKING IN MANUAL 2ND OR MANUAL 1ST POSITION

Possible Component	Reference/Action
250 - ELECTRICAL ROUTINE
	No Electrical Concerns
350 - HYDRAULIC/MECHANICAL ROUTINE
Shift Linkage
Damaged or incorrectly adjusted	Inspect and repair as required. Verify transmission shift cable adjustment; refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS . Adjust transmission shift cable as necessary. After repairing transmission shift cable, verify that the digital TR sensor is correctly adjusted. Adjust the digital TR sensor as necessary.
Main Controls
3-4 shift valve, 1-2 and 2-3 shift valve, gaskets, 3-4 capacity modulator valve, stuck or damaged or assembled incorrectly	Inspect for damage. Repair as required.
OD servo assembly damaged or stuck in manual 2nd only.	Inspect cover, piston and seal for damage. Repair as required.
Low/Reverse servo assembly damaged or stuck in manual 1st only	Inspect cover, piston and seal for damage. Repair as required.
Overdrive
Reverse band, manual 1st (only) damaged	Inspect for damage. Repair as required.
OD band, reverse clutch drum assembly worn or damaged (manual 2nd only)	Inspect for damage. Repair as required.
Reverse Band (Manual 1st Only)
Damaged or incorrectly adjusted	Inspect for damage. Repair as required.