LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1376 (Automatic Transmission) >> Diagnosis And Testing >> Diagnosis By Symptom >> Diagnostic Routines >> Engagement Concern: No Reverse

Engagement Concern: No Reverse

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
ENGAGEMENT CONCERN - NO REVERSE

Possible Component Reference/Action
202 - ELECTRICAL ROUTINE 
  • No Electrical Concerns
 
302 - HYDRAULIC/MECHANICAL ROUTINE 
Fluid   
  • Incorrect level
  • Adjust fluid to correct level.
  • Condition
  • Inspect condition of fluid.
Shift Linkage   
  • Damaged or incorrectly adjusted
  • Inspect and repair as required. Verify transmission shift cable adjustment; refer to AUTOMATIC TRANSAXLE/TRANSMISSION EXTERNAL CONTROLS . Adjust transmission shift cable as necessary. After repairing transmission shift cable, verify that the digital TR sensor is correctly adjusted. Adjust the digital TR sensor as necessary.
Incorrect Pressures   
  • Low reverse clutch pressure, low reverse band pressure, low line pressure
  • Check pressure at line pressure tap; refer to LINE PRESSURE CHART  for specifications. If pressures are low, check the following components: oil filter and seal assembly, main controls, reverse servo, pump assembly, reverse clutch assembly.
Fluid Filter and Seal Assembly   
  • Plugged, damaged
  • Install a new filter and seal assembly.
Main Controls   
  • No. 6 shuttle ball, manual valve, main regulator valve, 1-2 accumulator seals stuck or damaged
  • Inspect for damage. Repair as required.
  • Loose bolts
  • Tighten bolts to specifications.
  • Gasket damaged
  • Inspect for damage and install a new gasket.
Low/Reverse Servo   
  • Seals (piston and cover) damaged
  • Servo cover retaining ring damaged
  • Anchor pins (case) damaged
  • Inspect for damage. Repair as required.
Pump Assembly   
  • Loose bolts
  • Tighten bolts to specifications.
  • Porosity/cross leaks/ball missing or leaking, plugged hole
  • Inspect pump assembly. Install new as required.
  • Gasket damaged
  • Inspect for damage and install a new gasket.
  • No. 1 and 2 seal rings damaged
  • Inspect for damage. Repair as required.
Reverse Clutch Assembly   
  • Seals, piston damaged
  • Check ball missing or damaged
  • Friction elements damaged or worn
  • Inspect for damage. Repair as required.
Low/Reverse Band   
  • Band, servo, anchor pins damaged or worn
  • Inspect for damage. Repair as required.