LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Rear Disc Brake System) >> Removal And Installation >> Rear Brake Caliper >> Installation

Rear Brake Caliper: Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Make sure the anti-rattle clips are correctly positioned. Install new clips if worn or damaged.
  1. Position the anti-rattle clip on the anchor plate rail.
    2. CAUTION: To prevent interference with rear disc brake caliper operation, install only the correct caliper bolt.
    NOTE: When installed, the locator notch on the brake pads will be located at the upper end of the rear disc brake caliper.
  2. Position the brake caliper and install the 2 brake caliper bolts.
    • Tighten to 25 Nm (18 lb-ft).
  3. Position the brake hose and install the brake caliper flow bolt using 2 new copper washers.
    • Tighten to 50 Nm (37 lb-ft).
  4. Bleed the brake system. For additional information, refer to BRAKE SYSTEM-GENERAL INFORMATION .
    5. WARNING: If equipped with fire suppression system, repower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  5. If equipped with fire suppression system, repower the system.
  6. If equipped, turn the air suspension service switch to the ON position.
    7. NOTE: Apply the brakes several times before driving the vehicle.
  7. Verify correct brake operation.
scientia non olet · About LEMON Manuals