LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1349 (Wheels & Tires) >> Removal And Installation >> Wheel and Tire >> Removal

Wheel and Tire: Removal

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations. Failure to follow these instructions may result in personal injury.
  1. If equipped, turn the air suspension service switch to the OFF position.
    2. WARNING: If equipped with fire suppression system, depower the system. For important safety warnings and procedures, refer to FIRE SUPPRESSION SYSTEM .
  2. If equipped with fire suppression system, depower the system.
    3. CAUTION: Do not use heat to loosen a seized wheel nut. Heat can damage the wheel and wheel bearings.
  3. Remove the wheel cover or ornament and loosen, but do not remove, the wheel nuts.
  4. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
    5. CAUTION: Do not use heat to loosen a seized wheel. Heat can shorten the life of the wheel and damage the wheel bearings. If the wheel cannot be removed by hand, use a wheel puller.
  5. Remove the wheel and tire from the vehicle.
    • Remove the wheel nuts.
    • Remove the wheel and tire.
scientia non olet · About LEMON Manuals