Engine Timing

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

The PCM commands the fuel quantity. The fuel injection control module (FICM) controls the duration of the injection event and is shown as parameter identification (PID) FUELPW on the diagnostic tool.

The PCM controls the injection pressure and fuel volume by varying the injection oil pressure with the injection pressure regulator (IPR). The command to the IPR is a 12-volt, pulse width modulated (PWM) signal controlled on the ground side.

The injection oil pressure command is shown as PID IPR which is the percentage ON of the pulse width modulated signal. The injection oil pressure is shown as PID ICP.

The PCM uses camshaft position (CMP) and crankshaft position (CKP) input signals to calculate the engine speed and position. The PCM conditions both input signals and supplies the FICM with the CMP and CKP output signals. The FICM uses the CMP and CKP output signals to determine the correct sequence for injector firing. The PCM sends information about the fuel demand, engine oil temperature (EOT), and injection control pressure (ICP) through the CAN to the fuel injection control module (FICM). The FICM uses this information to calculate the injection cycle.