LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (Engine Controls - Diagnostic Methods -- 6.0L (99P F450/550) Diesel) >> On-Board Diagnostic (OBD) Drive Cycle >> OBD Pending DTCs

OBD Pending DTCs

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

Pending DTCs are DTCs that have only set during one drive cycle and may not have set the MIL yet. These DTCs can be identified using the retrieve pending DTCs feature. Additionally, they are found in the vehicle specific mode retrieve/clear continuous memory DTCs from the instant the DTC is set.

This function only reports pending failures that have occurred during the present or previous drive cycle, but does not indicate single failures that happened on any 2 previous drive cycles.