KOEO/KOER Output State Control (OSC)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.
Connect the diagnostic tool. Turn off all accessories. Turn the air conditioning (A/C) off. If the vehicle is equipped with a power take-off (PTO) system or auxiliary idle control, it must be turned off to carry out the self-tests. The outputs will be limited during KOEO output state control.
- Carry out the necessary vehicle preparation and visual inspection. Refer to QUICK TEST OPERATION .
- Refer to the manufacturer's manual for diagnostic tool instructions.
- Select KOEO/KOER output state control.
- Follow any special instructions on the screen.
- Use the diagnostic tool to access output PIDs.
- Cycle the output state on the exhaust gas recirculation (EGR), injection control pressure (ICP), fuel injectors, visctronic drive fan (VDF), variable geometry turbocharger (VGT), engine RPM, and fuel pump.
- Select PIDs.
- Activate OSC.
- After the test, cycle the key to the OFF position before running other tests or driving the vehicle.
- Clear all of the DTCs.