LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1332 (Engine Controls - Diagnostic Methods -- 6.0L (99P F450/550) Diesel) >> Basic Circuit Checks >> Description

Basic Circuit Checks: Description

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford RV Cutaway, 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Econoline. However, it is still accessible from the selected car via links, so may be relevant.

Basic circuit checks help to minimize pinpoint test steps by providing a procedure to diagnose harness faults associated with the electronic engine control (EEC) system. The following techniques provide helpful reminders for diagnosing open circuits (continuity), shorts to ground, and shorts to voltage.

NOTE:
  • The suspect circuit must be isolated before testing.
  • When disconnecting any harness connector, always inspect for damaged or pushed-out pins, corrosion, and loose wires. Repair as necessary.
  • The digital multimeter (DMM) must be set to the correct scale.
  • The techniques do no apply in all situations; therefore, it is necessary to carry out each pinpoint test step accurately and completely.
  • General resistance and voltage values are specified below. Always use the pinpoint test values if they differ.
  • Always turn the key to the OFF position unless directed otherwise by the pinpoint test.

Each of the following procedures requires the powertrain control module (PCM) and component to be disconnected to isolate the harness.

scientia non olet · About LEMON Manuals