LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P1270: Engine Rpm Or Vehicle Speed Limiter Reached

DTC P1270: Engine Rpm Or Vehicle Speed Limiter Reached

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Mariner, and 2006 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1270 - ENGINE RPM OR VEHICLE SPEED LIMITER REACHED

Description:  Indicates the vehicle has been operated in a manner which caused the engine or vehicle to exceed a calibration limit. The engine RPM and vehicle speed are continuously monitored and evaluated by the powertrain control module (PCM). The DTC is set when the RPM or vehicle speed falls out of a calibrated range. For additional information on the engine RPM/vehicle speed limiter, refer to POWERTRAIN CONTROL SOFTWARE .
Possible Causes: 
  • Wheel slippage (water, ice, mud, and snow)
  • Excessive engine RPM in NEUTRAL or operated in the wrong transmission gear
  • Vehicle driven at a high rate of speed
Diagnostic Aids:  The DTC indicates the vehicle was operated in a manner which caused the engine RPM or vehicle speed to exceed a calibrated limit.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All - - GO to Pinpoint Test ND .
scientia non olet · About LEMON Manuals