LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P1244: Alternator Load High Input

DTC P1244: Alternator Load High Input

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Mariner, and 2006 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P1244 - ALTERNATOR LOAD HIGH INPUT

Description:  The powertrain control module (PCM) monitors generator load from the generator/regulator in the form of frequency. The concern indicates the input is higher than the load should be in normal operation. The load input could be high when a battery short to ground exists.
Possible Causes: 
  • GENLI circuit short to voltage
  • GENRC circuit short to voltage
  • B+ open prior to start-up
  • Open GENRC prior to start-up
  • Open ILC prior to start-up
  • Damaged PCM
Diagnostic Aids:  Verify the battery voltage is 14.5 volts.
Verify the generator/regulator has the correct part number.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test HY .
scientia non olet · About LEMON Manuals