LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1328 (Engine Controls - Powertrain DTC Charts & Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> DTC P0704: Clutch Pedal Position (CPP) Switch Malfunction

DTC P0704: Clutch Pedal Position (CPP) Switch Malfunction

WARNING: This page does not describe the selected car, but rather 30 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Mariner, and 2006 Mercury Grand Marquis. However, it is still accessible from the selected car via links, so may be relevant.
P0704 - CLUTCH PEDAL POSITION (CPP) SWITCH MALFUNCTION

Description:  When the clutch pedal is applied the voltage goes to low. If the powertrain control module (PCM) does not see this change from high to low the DTC is set.
Possible Causes: 
  • CPP circuit short to voltage
  • Damaged CPP switch
  • CPP circuit open in the SIGRTN
Diagnostic Aids:  When the clutch pedal is applied and then released, the CPP switch voltage should cycle.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All GO to Pinpoint Test TA . - GO to Pinpoint Test TA .
scientia non olet · About LEMON Manuals