Accelerator Pedal Position (APP) Sensor
WARNING: This page does not describe the selected car, but rather 31 other vehicles, including the 2006 Mercury Mountaineer, 2006 Mercury Monterey, 2006 Mercury Montego, 2006 Mercury Milan, and 2006 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
The APP sensor is an input to the powertrain control module (PCM) and is used to determine the torque demand. There are 3 pedal position signals in the sensor. Signal 1, APPS1, has a negative slope (increasing angle, decreasing voltage) and signals 2 and 3, APPS2 and APPS3, both have a positive slope (increasing angle, increasing voltage). During normal operation APPS1 is used as the indication of pedal position by the strategy. The 3 pedal position signals make sure the PCM receives a correct input even if 1 signal has a concern. There are 2 reference voltage circuits and 2 signal return circuits for the sensor. For additional information, refer to TORQUE BASED ELECTRONIC THROTTLE CONTROL (ETC) .