Side Impact Sensor - Second Row, C-Pillar: Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Install the C-pillar side impact sensor.
- Install the side impact sensor bolts.
- Tighten to 12 Nm (9 lb-ft).
- Connect the side impact sensor electrical connector.
- Install the rear seat bolster on the side with the affected C-pillar side impact sensor. For additional information, refer to SEATING .
- Repower the system. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING in this article.
- Check the active restraint system for correct operation. For additional information, refer to SAFETY BELT SYSTEM .
NOTE:
Align the locator tab of the second row side impact sensor mounting bracket to the opening in the C-pillar sheet metal.
WARNING:
The tightening torque of the air bag side impact sensor retaining bolts is critical for correct system operation.