Removal and Installation
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the headlamps. For additional information, refer to EXTERIOR LIGHTING .
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the 6 screws, the pin-type retainer, and the front valance panel.
- Remove the 6 lower fender splash shield screws.
- Disconnect the 2 fog lamp electrical connectors.
- Remove the 4 front bumper cover bracket bolts from the fenders.
- To install, tighten to 7 Nm (62 lb-in).
- Pull the center tabs downward and the outboard tabs on each side outward and remove the front bumper cover.
- To install, reverse the removal procedure.