LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1316 (Roof Opening Panel) >> Removal And Installation >> Roof Opening Panel Shield >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the roof opening panel glass. For additional information, refer to ROOF OPENING PANEL GLASS .
  2. Unsnap front of trough assembly from the mechanism.
  3. Rotate the trough arms upward to allow shield to be pulled forward in front of the trough.
  4. Pull the roof opening panel shield forward so the rear of the shield passed below and in front of the trough.
  5. Remove the roof opening panel shield.
    • Lift the forward edge slightly.
    • Release the front and rear tabs from the roof opening panel frame tracks.
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals